Pipes and Bases for an 8 foot high x 10 foot wide back drop! NOTE: THIS LISTING IS FOR THE FRAMEWORK (PIPES AND BASES) ONLY. What's Included In The Listing. 2 pieces: 8'H Silver Aluminum Slip-Fit Uprights, 1.5 Diameter -- CHOOSE FROM FIXED (ONE PIECE) OR BREAK APART (2 PIECE).2 pieces: 16" x 14" Silver Steel Slip-Fit Bases with Base Pins (optional base edge protectors). 1 piece: Adjustable 6-10 Foot Width Silver Aluminum Drape Support Rod. Fixed Upright = one piece. Does not adjust or break down in to smaller sections. If you set-up at various locations, please ensure that you have a vehicle that can transport an 8 foot pipe. Break Apart Upright = two pieces. Does not adjust in height, but breaks down in to 2 smaller sections; one is 4 feet, and the other is 4 feet 4 inches. When the two pieces are put together, it creates an 8 foot Upright. This makes transportation easier if you travel with your set-up and do not have a vehicle that can accommodate a fixed 8 foot pipe. Please note that there is a little more "wiggle room" to Break Apart Uprights since they are two pieces instead of a single solid piece. Edge Protectors = the edges of the bases can be raw or rough. Edge protectors help protect your hands and flooring.
Size - 96"H x 1.5" diameter Weight - Approximately 2.1 lbs each Material - Aluminum Color - Silver Other - Four 90° slots are cut out at 36H and at the top. Size - 16" x 14" with stacking slot Weight. Approximately 10 lbs each with included 3H steel base pin.
Material - Steel Color - Silver Other - Edge protectors optional. Drape Support Rod (horizontal pipe). Size - 72"L at collapsed size, 120"L at fully extended size, 1.5 diameter Weight - Approximately 3.5 lbs.
Weight capacity is 15 lbs. Material - Aluminum Color - Silver Other - Adjustable from 6 to 10 feet wide. Button stop at 8 and 10 foot intervals.
What Is The Slip-Fit System? The slip-fit system is designed to be a tremendous time saver for setting up and breaking down your pipe and drape display. The uprights are hollow, allowing them to simply slip over the base pin (included with each base). The drape support rod features steel hooks at each end that slip inside of one of the four slots cut out at the top of the upright. Estimated set-up time varies based on the number of people and the speed at which he or she works, but should average about 5-10 minutes once the boxes are unpacked.
The only tool required is a flat head screwdriver to screw the base pin onto the base (a very simple task). Other than that, no tools for assembly are required. IMPORTANT - Policies and Terms/Conditions. Please open and inspect all contents immediately. All items must be new, unused, and the drapes must be unwashed.
Are intended for indoor, decorative use only. They should never be used where tip-over may cause injury or damage. Failure to use these products as intended will likely affect the safety of the products used and can result in injury or damage for which we are not responsible.
The maximum weight capacity for the drape support rod is 15 pounds. Any box that is delivered, or component piece within a box, may be sharp, and should be handled with care. Your order from us represents that you have read and agree to our. We answer any and all questions as quickly as possible. We also sell all component pieces separately if an entire kit is not needed.
The item "8 FT HIGH x 10 FT WIDE PIPE AND BASE KIT (NO DRAPE) PIPE & DRAPE FRAMEWORK" is in sale since Tuesday, March 17, 2015. This item is in the category "Home & Garden\Wedding Supplies\Venue Decorations". The seller is "act201" and is located in Marietta, Georgia. This item can be shipped to United States.